Planet-9 Porsche Forum banner
  • Hello Everyone! Let us know what you would spend a $50 Amazon gift card on, HERE For a chance to win a $50 Amazon Gift Card!
1 - 3 of 3 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
Hi
To mount a front splitter I need to raise, of course, the front of the car some inches. In the absence of a work shop for the moment, where is it possible to put the jack screw? Is there any durable spot somewere between the front wheels you can use?

Thanks in advance//PC

987S 2008
 

·
Registered
Joined
·
897 Posts
There is no central recommended central lifting point on the front of a 987 to my knowledge.

If I were doing work on the front splitter I'd drive the car up onto ramps if they were available, IMHO it would be the safest method.

If ramps are not available I would only use the the recommended Porsche jacking points ( photo attached ).

After jacking up one side of the car I would simply put wooden blocks under that tire and then switch to the other side and repeat the process.

Be sure the car is in gear, parking brake is set and rear wheels are chocked.

Good luck.
 

Attachments

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top