[Magnetpro]

OEM KEY REFURBISHMENT

Start off with a video I did on refurbishing the Cayman keys that are a terrible design from the factory. I show all the steps from popping the OEM key to closing the new housing. Transponder lifted over and I had 0 failes and "in-pocket-frunk-openings" after I did this update

Hope you like it.

https://www.youtube.com/watch?v=9s-ch13GmSY

 

[Magnetpro]

TITANIUM WHEEL BOLTS

Next is a "technical" review of Tikore Titanium bolts compared with OEM. They are not cheap but they are soooo pretty... Say hi to Charlie from me if you contact Tikore.com

Hope you like it

https://www.youtube.com/watch?v=vL1qz7u-qUw&t=3s&list=PLlgA6le4xc4txSVOKP_QKjgoECjld2atY&index=11

 

[Magnetpro]

REMOVE REAR SUSPENSION

In my chase for performance I opted to install coilovers and the car naturally is on rails now as compared with before. Downside is that I discovered in what terrible state our roads are in.

https://www.youtube.com/watch?v=_xPSTKjEo5k&t=38s&list=PLlgA6le4xc4txSVOKP_QKjgoECjld2atY&index=12

 

[Magnetpro]

DETAIL BRAKE CALIPERS

Since the disks and pads were up for replacement and braided lines to be in stalled I opted for clean and detail the calipers when they were loose.

https://www.youtube.com/watch?v=KoNIhgf9wGw&t=215s&list=PLlgA6le4xc4txSVOKP_QKjgoECjld2atY&index=13

 

[Magnetpro]

OIL BYPASS VALVE

Until recently I didn't know the oil system had a bypass valve (in the oil filter for once) that kick in when oil is cold, filter is clogged and engine under high load

https://www.youtube.com/watch?v=vRwJxGFv2ZU&list=PLlgA6le4xc4txSVOKP_QKjgoECjld2atY&index=14

 

[Magnetpro]

BRAKE DISK COMPARISON

I opted to go for floating PFC disks in the front and Brembo OEM disks in the rear. Haven't had possibility to test them to the limit yet but I'll get there!

https://www.youtube.com/watch?v=uRmF5yvSIPg&t=7s&list=PLlgA6le4xc4txSVOKP_QKjgoECjld2atY&index=15

 

[Magnetpro]

GEARBOX OIL CHANGE

The hard way by dismantling the rear subframe instead of just drilling a hole in the plate. But as usual when I do something I need to clean it and make it look pretty.

https://www.youtube.com/watch?v=dqVnkmfWwLo&list=PLlgA6le4xc4txSVOKP_QKjgoECjld2atY&index=16

 

[Magnetpro]

MOUNTING OF 3RD COOLER

I could not stand the ugly plastic cover in the very front of the bumper and since its is prepared for a 3rd cooler I added that. Before I could hear the fron cooler fans run from time to time. This season I haven't heard them once yet

https://www.youtube.com/watch?v=hcGFFw9gsjg&t=4s&list=PLlgA6le4xc4txSVOKP_QKjgoECjld2atY&index=17

 

[Magnetpro]

FRONT BUMPER REMOVAL

In order to be able to install the front 3rd cooler I needed to remove the front bumper. Lots on nuts and screws but not as intimidating as it first seemed.

https://www.youtube.com/watch?v=VbtE35rg5WA&t=5s&list=PLlgA6le4xc4txSVOKP_QKjgoECjld2atY&index=18

 

[eyeofthetiger]

tobe, great work on the videos - looks like you're quite a DIY person and very good with tools!
:cheers:

 

[danschy]

Very nice work. Seems like these videos should be referenced in the Articles area.

 

[Magnetpro]

quite so have a hard time "leave things as is" and also doing things on my own is a condition for being able to afford the ownership. Changing oil or a filter is "kids work" for me so I only hand it over to a repair shop if its really serious

 

[Magnetpro]

Thanks, initially looked at adding them ti the articles section but it only related to written "How To" so I didn't dare to put them there to risk having them removed. If admin is happy to accept them Im happy to have them in there.

 

[Von Hanstein]

Thank you. I learned more from you in the videos than I have from CNN in a week. Your information is actually useful. Keep up the good work!

 

[shifterkartracer]

This is Awesome thank you!!!
I will be adding a 3rd Radiator before next summer.