I bought a 100k mile 2009 997.2 C2 PDK. After getting it home, the high pressure fuel pump failed. I replaced that and now get these codes:
Siemens Digital Motor Electronics SDI3
Current Fault Codes 2310: Bar ignition module, cylinder 4 - Upper limit value exceeded
Transmission - PDK
Current Fault Codes C418: U0418 - CAN fault, brake
I haven't found anything online relating to these issues. The car still feels a little down on power (but better than before the pump was replaced) and the gear shifts are a little clunky at low speed. Any ideas?
Siemens Digital Motor Electronics SDI3
Current Fault Codes 2310: Bar ignition module, cylinder 4 - Upper limit value exceeded
Transmission - PDK
Current Fault Codes C418: U0418 - CAN fault, brake
I haven't found anything online relating to these issues. The car still feels a little down on power (but better than before the pump was replaced) and the gear shifts are a little clunky at low speed. Any ideas?