Planet-9 Porsche Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2,467 Posts
The metal clip is what essentially holds the side marker in place and it's obvious that you need to adjust/bend the clip so that it holds again. Pulling the light out can cause the clip problem so it should be a minor adjustment to bend it back in place to hold the light. If it still doesn't light after reinstalling I would try replacing the bulb next.

Good luck.
 

·
Registered
Joined
·
2,467 Posts
Haven't had that one go out but when my left brake light bulb went out I did receive a message to that effect, but mentioning the brake light of course. If you buy a replacement anywhere besides the dealer make sure the watts rating is the same otherwise it will work BUT the message won't clear from your dash.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top