Planet-9 Porsche Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi all,

I just put in a set of Sparco EVO II US seats in my 987.1 cayman S. I used Sparco hardware which including base mount (for 6 point harness mount), sliders, and side mounts. Unfortunately, the new seat sits a couple of inches higher than the lowest point on the stock seats! My head (without a helmet, is only about an inch from hitting the roof.

I'm not sure how to properly get the seat lower. The rear mounting point of the seat is as low as it can be with this set up. I would ultimately like to maintain the functionality of sliders for these seats as I am not the only person who drives the car.

Does anyone have any recommendations on how to lower the seat? At this point I am open to any reasonable suggestion as the seats will not work in their current state.

Thanks!
 
1 - 1 of 1 Posts
Top