Planet-9 Porsche Forum banner
1 - 12 of 140 Posts

· Registered
Joined
·
1,134 Posts
Hi guys, a couple of things: Jeff your bent tube drain idea works!
I also cut down an old irrigation sprinkler the same size as the pan hole and was able to put the socket and torx bit inside it to remove the drain. There was almost no spillage!
How did you and @jjrichar get the siphoning to start with the bent tube into the pan hole? 🤯
 

· Registered
Joined
·
1,134 Posts
I did only do it with water when I conducted the experiment. Would be easy to get the fluid moving by using a vacuum bleeder and then let gravity take over once it gets moving. Or just use a vacuum bleeder for all of the additional fluid removal using the bent hose.
I guess I’ve had worse …. Hoping to do the first fluid flush on Friday, finally


Shawn in VA (USA)
 

· Registered
Joined
·
1,134 Posts
Sanity check please. This Porsche Pentosin Transmission Oil is the correct PDK “clutch fluid” ? P/N shows 000.043.305.13. Someone posted above .12. Thanks.



Shawn in VA (USA)
 

· Registered
Joined
·
1,134 Posts
It is 000-043-305-13. I just checked my last Pelican Parts order. C.
Thanks for the research and prompt response. I was under the car and second guessing myself.

Got bother fluids swapped. Won’t be able to drive it for at leas a few day .

On the hunt for placemats at the Dollar Store I found these cheap “cutting boards” that did the trick.





Fluid looked pretty good to the naked eye.




Shawn in VA (USA)
 
1 - 12 of 140 Posts
Top